Copper Aluminum Radiator Separator Recycling Machine

Time:2022-06-13

Copper Aluminum Radiator Separator Introduction
Radiator separator recycling machine is designed to process scrap aluminum copper radiators normally used in air conditioning units. Cut the clean radiator neatly into 30-40cm wide, and then put it into the material inlet, within seconds copper pipes and aluminum fin will be discharged separately. Copper pipe will keep complete, while aluminum fin will be a little broken for one-row radiator and keep complete for two-row radiator. The machine proves itself to be the best choice for scrap radiator recycling.

Copper Aluminum Radiator Separator Recycling Machine

Features of  Copper Aluminum Radiator Separator
1. Compact structure, taking up small area.
2. Humanized design, easy to operate.
3. High efficiency, separation within seconds.
4. Labor saving, use automatic recycling instead of labor working.
5. No damage to copper pipes, no copper loss, practical and economical.
6. Low investment, high profit.
7. The voltage can be customized as per your requirements

 

Application of Copper Aluminum Radiator Separator
1. The radiator recycling machine is specially used for processing aluminum-copper radiators.
2. The radiator recycling machine is suitable for separating one-row and two-row radiators. For radiators of more than 2 layers, please use a band saw to cut them into one layer or two layers.
3. Center distance of two copper pipes in radiators shall be 19mm or 21mm or 25mm. We could also customize it as per the specific conditions.

 

Working Process of Copper Aluminum Radiator Separator
1. Cut off the iron ends from the radiator, in case they will damage the blades.
2. Cut the clean radiators to 30-40cm wide with a band saw to fit the width of the material inlet (We also provide the band saw if you need it).
3. To process two-row radiators, remove the roller from the lower cutter shaft to expose the blades.
4. Push radiators into material inlets according to the respective center distance, the left(right) side of radiators must touch the left(right) side of the material inlet, thus each feeding gear will be in the middle of each two copper pipes.
5. For two-row radiators, the first copper pipe in the upper layer shall be nearer to the left side, otherwise the copper pipes won’t come out. You can also make the right side of radiators touch the right side of material inlets, then the first copper pipe in the lower layer shall be nearer to the right side.
6. Feeding gears gnaw at radiators and take them into the machine, the blades are right above each copper pipe and gash the aluminum fin, then copper pipes and aluminum fin will come out from the outlet automatically.

 

Radiator Recycling