Automatic Industrial Straight Knife Sharpening Grinding Machine

Time:2021-12-07

Automatic Industrial Straight Knife Sharpening Grinding Machine introduction:
Straight knife grinding machine equipment is a professional used in straight blade and grinding a variety of oblique face grinding machines. PNMD-B series is a professional for grinding all kinds of oblique or straight blade end face grinding machines, with short grinding time, the grinding amount is small, high grinding accuracy, sharp edge characteristics, are small printing, packaging enterprises and individual users of the ideal grinding equipment.

knife sharpening grinding machine, automatic knife grinding machines, knife grinding machine, blade grinding machine for sale, industrial knife grinder for sale

The grinding wheel selection of Straight Knife Sharpening Grinding Machine is mainly as follows:
1) The grinding wheel size selection problem, according to the finish you need to choose the size
2) The hardness of grinding wheel is generally K-L, which will consume quickly if it is soft but will not grind if it is hard
3) Generally choose white corundum and chrome corundum can

Automatic Industrial Straight Knife Sharpening Grinding Machine Video:

Straight Knife Sharpening Grinding Machine before its operation, notes are as follows:
1. before operating the straight knife grinder machine, be sure to read the manual carefully to prevent the operation error, resulting in accidental injury.
2. Check whether the three-phase and four-wire electricity of the knife grinder is normal and whether the running direction of the grinding head and the grinding wheel is consistent with the direction indicated by the travel button.
3. During the operation of the machine, the track should be lubricated with oil at any time to prevent the track from being worn due to lack of oil.
4. In the process of checking the knife, if there is an error on the left and right, it can be adjusted by the adjusting screw on the tool holder.
5. straight knife grinder in the process of grinding, should pay attention to the feed can not be too large, generally controlled between 0.01-0.02mm, to prevent too much feed caused by paste knife and high heat deformation of the blade, so that the blade edge is not in a straight line.
6. When the burr appears on the edge of the blade, it means that the blade has been polished. At this time, there is no need to feed the blade until the spark becomes small. (The use method of the oil stone attached to the instruction manual must be strictly followed)
7. when the machine is not in use, it is necessary to wipe the water stains on the knife holder, butter or oil, to prevent rust.
8. Oil filling holes on the machine must be filled before starting the machine at work every day.
9. the operator in the process of sharpening the knife and the installation of the blade in the process must be consistent, to prevent danger caused by personal injury.